Welcome to the

City of Palmdale, CA

City Banner

Installation

Banner Installation Guidelines:

Step 1:

Attach the top bracket with banding straps at the confirmed display height.

Step 2:

Confirm the arrow on the metal base of the top rod is pointing towards the sky

Arrow on Bracket:

Correctly Installed:

Arrow on Top Bracket Pointing Up

(Stretches the Banner – No Sag or Roll)

Step 3:

Fastened the rod to the pole with the metal straps

(2) Straps for Each Rod

Step 4:

Slide the top banner sleeve onto the top rod

Step 5:

Slide the other rod through the bottom sleeve of the banner

Step 6:

Confirm the arrow on the metal base of the bottom rod is pointing down to the ground

Arrow on Bracket:

Correctly Installed

Arrow on Bottom Bracket Pointing Down

(Stretches Banner – No Sag or Roll)

Step 7:

Fastened the rod to the pole with the metal straps

(2) Straps for Each Rod

Step 8:

Feed the zip tie through the eye screw and the grommet on the banner.

(Avoid over tightening the zip tie)

Correctly Installed:

Zip Tie Fastened Loosly

(Not Pulling on Banner Creating a Roll)

Step 9:

Insert the cotter pins through the holes in the ends of the fiberglass rods

Cotter Pin Inserted:

Step 10:

Trim excess straps back leaving approximately 3-5″ of strap only.

(Avoid leaving excessive strap)

Correctly Installed:

(3-5″ of Strap)

Step 11:

Take a Picture of the Installed Banner

Picture Focused on the Banner and Hardware:

(Good Picture)

Installation Checklist:

Street Lamp Map:

Community Showcase Banners
130 E. Main St.
Rochester, NY 14604